Fujian Ningde Traditional Chinese Medicine Ultrafine Powder Dust-Free Feeding and Conveying Project
A certain traditional Chinese medicine decoction piece manufacturer has long faced issues such as dust escaping, high material loss, and poor on-site work conditions during the feeding and transportation of ultrafine powders (such as Sanqi powder and Ganoderma spore powder). The company's original exposed feeding method led to severe fine powder dispersion, requiring workers to wear dust masks, and the material loss rate per batch exceeded 5%, along with cross-contamination risks.
Customer pain points

1. Severe dust pollution: Ultrafine powder has small particle size and light weight, and during traditional manual feeding, large amounts of dust are raised, endangering employee health and making it difficult to meet environmental protection requirements.
2. High material loss: Fine powder tends to remain, stick to walls, or escape during transportation, resulting in actual output lower than the theoretical feed volume and persistently high costs.
3. Low production efficiency: manual handling, unpacking, and feeding are time-consuming and labor-intensive, making continuous and stable supply difficult and limiting subsequent automation upgrades on production lines.
4. Difficult cleaning and maintenance: The inner walls of equipment tend to adhere to ultrafine powders, and frequent shutdowns for cleaning affect overall production capacity.
Solutions and product advantages

To address these pain points, Head Powder deployed a pneumatic delivery system for ultrafine Chinese medicine powders for the company, along with a dust-free feeding station. This solution uses sealed pipelines for negative pressure transmission, preventing dust leakage from the source. The feed inlet is equipped with an active dust removal and filtration device that simultaneously collects and reuses the flying fine powder, lowering the dust concentration in the on-site environment to compliant levels. Materials are fully sealed throughout the transportation process, reducing contact with the outside world and lowering the risk of cross-contamination. The system adopts anti-adhesion inner wall design and pneumatic artery rush backblow technology to improve fine powder attachment issues and support smooth conveying. At the same time, the modular design supports linkage control with front-end crushing and back-end mixing packaging equipment, achieving full automation throughout the process. Each unit can supply materials continuously and stably, with efficiency more than three times higher than manual labor.
Application Effectiveness

After the project was implemented, the company's dust emission concentration dropped by over 90%, material loss rate dropped from 5% to within 0.5%, on-site cleaning cycles were extended to once a week, and operators no longer needed to wear dust masks. The overall production capacity has increased by about 40%, meeting the requirements of Good Manufacturing Practice (GMP) for clean environments.